Dell PowerConnect 8024 User Configuration Manual page 816

NOTE:
FIP snooping will not allow FIP or FCoE frames to be forwarded over a
port until the port is operationally enabled for PFC. VLAN tagging must be
enabled on the interface in order to carry the dot1p values through the network.
This section describes the FIP snooping commands only. For an example of
configuring FIP snooping on the switch, see "FIP Snooping Configuration
Example" on page 817.
Command
configure
feature fip-snooping
vlan_id
vlan
fip-snooping enable
fip-snooping fc-map
fc_map_value
exit
interface
interface
fip-snooping port-mode
fcf
CTRL + Z
show fip-snooping
sessions
816
Configuring Data Center Bridging Features
Purpose
Enter global configuration mode.
Globally enable FIP snooping on the switch.
Enter VLAN configuration mode for a VLAN or range of
VLANs.
Enable the snooping of FIP packets on the specified VLAN
or VLAN range.
Optionally configure the FC-MAP value on a VLAN. The
FC map value is used to help prevent the switch from
being incorrectly configured. The range for
is 0x0–0xffffff.
The FC map value configured on the switch must match
the FC map value configured on the FCF for the VLAN.
Exit to global configuration mode.
Enter interface configuration mode for the specified
interface
interface. The
and number, for example tengigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Configure the interface to be connected to a FCF switch.
Exit to Privileged EXEC mode.
Display information about the active FIP snooping
sessions.
variable includes the interface type
fc_map_value