Managing The Stack (Cli); Configuring Stack Member, Stack Port, And Nsf Settings - Dell PowerConnect 8024 User Configuration Manual

Managing the Stack (CLI)

This section provides information about the commands you use to manage
the stack and view information about the switch stack. For more information
about these commands, see the
8024/8024F/8132/8132F/8164/8164F CLI Reference Guide at
support.dell.com/manuals.

Configuring Stack Member, Stack Port, and NSF Settings

Beginning in Privileged EXEC mode, use the following commands to
configure stacking and NSF settings.
Command
configure
current_ID
switch
new_ID
renumber
stack
movemanagement
from_unit to_unit
unit
standby
set description
162
Managing a Switch Stack
Purpose
Enter Global Configuration mode.
Change the switch ID number. The valid range is 1-10.
NOTE:
Changing the ID number causes all switches in the
stack to be reset to perform stack master renumbering. The
running configuration is cleared when the units reset.
Enter Global Stack Configuration mode.
Move the management switch functionality from one
switch to another.
Specify the stack member that will come up as the master
if a stack failover occurs.
unit
Configure a description for the specified stack member.
PowerConnect