Dell PowerConnect 8024 User Configuration Manual page 980

Command
ip ospf dead-interval
seconds
ip ospf transmit-delay
seconds
ip ospf mtu-ignore
ip ospf network
{broadcast | point-to-
point}
ip ospf authentication
{none | {simple
key key-id
{encrypt
interface-
ip ospf cost
cost
bw
bandwidth
980
Configuring OSPF and OSPFv3
Purpose
Set the OSPF dead interval for the interface.
seconds
The
router waits to see a neighbor router's Hello packets before
declaring that the router is down (Range: 1–65535).
This parameter must be the same for all routers attached
to a network. This value should be some multiple of the
Hello Interval.
Set the OSPF Transit Delay for the interface.
seconds
The
seconds it takes to transmit a link state update packet over
this interface. (Range: 1–3600 seconds)
Disable OSPF MTU mismatch detection on the received
database description.
Set the OSPF network type on the interface to broadcast
or point-to-point. OSPF selects a designated router and
originates network LSAs only for broadcast networks. No
more than two OSPF routers may be present on a point-
to-point link.
Set the OSPF Authentication Type and Key for the
key
} | specified interface.
}}
• encrypt — MD5 encrypted authentication key.
key
• — Authentication key for the specified interface.
(Range: 8 bytes or less if the authentication type is
simple and 16 bytes or less if the type is encrypt.)
key-id
•
authentication type encrypt. (Range: 0–25)
Set the metric cost of the interface.
interface-cost
The
metric) of the OSPF interface. (Range: 1–65535)
Set the interface bandwidth used in the formula to
compute link cost for an interface:
link cost = ref_bw÷interface bandwidth
bw
The variable is the interface bandwidth (Range:
1–10000000 Kbps).
variable indicates the number of seconds a
variable sets the estimated number of
— Authentication key identifier for the
variable specifies the cost (link-state