Link Aggregation Configuration Examples; Configuring Dynamic Lags - Dell PowerConnect 8024 User Configuration Manual

Link Aggregation Configuration Examples

This section contains the following examples:
•

Configuring Dynamic LAGs

• Configuring Static LAGs
NOTE:
The examples in this section show the configuration of only one switch.
Because LAGs involve physical links between two switches, the LAG settings
and member ports must be configured on both switches.
Configuring Dynamic LAGs
The commands in this example show how to configure a static LAG on a
switch. The LAG number is 1, and the member ports are 1, 2, 3, 6, and 7.
To configure the switch:
1 Enter interface configuration mode for the ports that are to be configured
as LAG members.
console(config)#interface range te1/0/1-3,te1/0/6-7
2 Add the ports to LAG 2 with LACP.
console(config-if)#channel-group 1 mode active
3 View information about LAG 1.
console#show interfaces port-channel 1
Channel Ports
------- -----------------
Po1 Inactive: Te1/0/1,
Te1/0/2, Te1/0/3,
Te1/0/6, Te1/0/7
Hash Algorithm
--------------
3
Configuring Link Aggregation
Ch-Type min-links
------- ---------
Dynamic 1
797