Console Port; Out-Of-Band Management Port; Power Supplies - Dell PowerConnect 8024 User Configuration Manual

The following image show the back panel of the PowerConnect 8000-series
and 8100-series switches.
Figure 3-7. PowerConnect 8000-series and 8100-series Rear Panel
AC power OOB Ethernet port

Console Port

The console port is for management through a serial interface. This port
provides a direct connection to the switch and allows you to access the CLI
from a console terminal connected to the port through the provided serial
cable (RJ-45 to female DB-9 connectors).
The console port supports asynchronous data of eight data bits, one stop bit, no
parity bit, and no flow control. The default baud rate is 9600 bps.

Out-of-Band Management Port

The Out-of-Band (OOB) management port is a 10/100/1000BASE-T
Ethernet port dedicated to remote switch management. Traffic on this port is
segregated from operational network traffic on the switch ports and cannot be
switched or routed to the operational network.

Power Supplies

Each PowerConnect 8000-series and 8100-series switch has two power
supplies for redundant or loadsharing operation. Each power supply can
support 300W.
CAUTION:
Remove the power cable from the modules prior to removing the
module itself. Power must not be connected prior to insertion in the chassis.
RJ-45 serial console port
Fans (3) AC power
Hardware Overview
93