Configuring Stub Areas And Nssas - Dell PowerConnect 8024 User Configuration Manual

Command
exit
router ospf
passive-interface vlan
vlan-id
ip-address
network
wildcard-mask
area
id
exit
exit
show ip ospf interface
vlan-id
[vlan ]
show ip ospf interface
vlan-id
stats vlan

Configuring Stub Areas and NSSAs

Beginning in Privileged EXEC mode, use the following commands to
configure OSPF stub areas and NSSAs.
Command
configure
router ospf
area-id
area stub
area-id
area stub no-
summary
Purpose
Exit to Global Configuration Mode
Enter OSPF configuration mode.
Make an interface passive to prevent OSPF from forming
an adjacency on an interface. OSPF advertises networks
attached to passive interfaces as stub networks.
Enable OSPFv2 on interfaces whose primary IP address
area-
matches this command, and make the interface a member
of the specified area.
ip-address
•
wildcard-mask
•
subnet.
area-id
• — The ID of the area (Range: IP address or
decimal from 0–4294967295).
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View summary information for all OSPF interfaces
configured on the switch or for the specified routing
interface.
View per-interface OSPF statistics.
Purpose
Enter global configuration mode.
Enter OSPF configuration mode.
Create a stub area for the specified area ID.
Prevent Summary LSAs from being advertised into the
stub area.
— Base IPv4 address of the network area.
— The network mask indicating the
Configuring OSPF and OSPFv3
981