Dell PowerConnect 8024 User Configuration Manual page 977

Command
default-information
originate [always]
metric-value
[metric
type-value
[metric-type
metric-
default-metric
value
distance ospf {external |
inter-area | intra-area }
distance
enable
exit-overflow-interval
seconds
external-lsdb-limit
integer
maximum-paths
Purpose
Control the advertisement of default routes.
• always — Normally, OSPF originates a default route only
]
if a default route is redistributed into OSPF (and default-
]
information originate is configured). When the always
option is configured, OSPF originates a default route,
even if no default route is redistributed.
metric-value
•
default route. (Range: 1–16777214)
type-value
•
route or External type-2 route.
Set a default for the metric of distributed routes (Range:
1–16777214).
Set the preference values of OSPF route types in the
router.
The range for the
preference values are preferred when determining the best
route.
Enable OSPF.
Specify the exit overflow interval for OSPF as defined in
RFC 1765.
The interval is the number of seconds after entering
overflow state that a router will wait before attempting to
leave the overflow state. (Range: 0–2147483647)
limit
Configure the external LSDB limit for OSPF as defined in
RFC 1765. If the value is –1, then there is no limit.
limit
The variable is the maximum number of non-default
AS external-LSAs allowed in the router's link-state
database. (Range: 1 to 2147483647)
Set the number of paths that OSPF can report for a given
destination (Range: 1–4).
— The metric (or preference) value of the
— The value is either 1 or 2: External type-1
distance
variable is 1–255. Lower route
Configuring OSPF and OSPFv3
977