Dell PowerConnect 8024 User Configuration Manual page 301

Command
snmp-server v3-host {
address hostname
|
username
{traps |
informs} [noauth | auth
| priv] [timeout
seconds retries
] [retries
port
[udpport ] [filter
filtername
]
exit
show trapflags
Purpose
ip-
For SNMPv3, configure the system to receive SNMP traps
} or informs.
ip-address
•
(targeted recipient).
hostname
•
]
158 characters.)
username
•
notification. (Range: 1-25 characters.)
• traps — Indicates that SNMP traps are sent to this host.
• informs — Indicates that SNMPv2 informs are sent to
this host.
• noauth — Specifies sending of a packet without
authentication.
• auth — Specifies authentication of a packet without
encrypting it
• priv — Specifies authentication and encryption of a
packet.
seconds
• — Number of seconds to wait for an
acknowledgment before resending informs. This is not
allowed for hosts configured to send traps. The default is
15 seconds. (Range: 1-300 seconds.)
retries
• — Maximum number of times to resend an inform
request. This is not allowed for hosts configured to send
traps. The default is 3 attempts. (Range: 0-255 retries.)
port
• — UDP port of the host to use. The default is 162.
(Range: 1-65535.)
filter-name
•
the snmp-server filter command) to use for the host.
(Range: 1-30 characters.)
Exit to Privileged EXEC mode.
View the status of the configurable SNMP traps.
— Specifies the IP address of the host
— Specifies the name of the host. (Range: 1-
— Specifies user name used to generate the
— Specifies the optional filter (defined with
Configuring SNMP
301