Configuring Ipsg - Dell PowerConnect 8024 User Configuration Manual

Configuring IPSG

This example builds on the previous example and uses the same topology
shown in Figure 27-25. In this configuration example, IP source guard is
enabled on ports 1-20. DHCP snooping must also be enabled on these ports.
Additionally, because the ports use IP source guard with source IP and MAC
address filtering, port security must be enabled on the ports as well.
To configure the switch:
1 Enter interface configuration mode for the host ports and enable IPSG.
console(config)#interface range te1/0/1-20
console(config-if)#ip verify source port-security
2 Enable port security on the ports.
console(config-if)#port security
3 View IPSG information.
console#show ip verify source
Interface
---------
Te1/0/1
Te1/0/2
Te1/0/3
Te1/0/4
Te1/0/5
--More-- or (q)uit
Filter IP Address
------- ----------
ip-mac 192.168.3.45
ip-mac 192.168.3.40
ip-mac 192.168.3.33
ip-mac 192.168.3.18
ip-mac 192.168.3.49
MAC Address
00:1C:23:55:D4:8E
00:1C:23:12:44:B6
00:1C:23:AA:B8:01
00:1C:23:67:D3:CC
00:1C:23:55:1B:6E
Snooping and Inspecting Traffic
Vlan
100
100
100
100
100
779