Dell PowerConnect 8024 User Configuration Manual page 988

Command
distance ospf {external |
inter-area | intra-area }
distance
enable
exit-overflow-interval
seconds
external-lsdb-limit
maximum-paths
maxpaths
passive-interface default Configure OSPFv3 interfaces as passive by default. This
exit
exit
show ipv6 ospf
clear ipv6 ospf
[{configuration |
redistribution | counters
| neighbor [interface
vlan-id
vlan
neighbor-id
[ ]]}]
988
Configuring OSPF and OSPFv3
Purpose
Set the preference values of OSPFv3 route types in the
router.
The range for the
preference values are preferred when determining the best
route.
Enable OSPFv3.
Specify the exit overflow interval for OSPFv3 as defined in
RFC 1765.
The interval is the number of seconds after entering
overflow state that a router will wait before attempting to
leave the overflow state. (Range: 0–2147483647)
limit
Configure the external LSDB limit for OSPFv3 as defined
in RFC 1765. If the value is -1, then there is no limit.
limit
The variable is the maximum number of non-default
AS external-LSAs allowed in the router's link-state
database. (Range: –1 to 2147483647)
Set the number of paths that OSPFv3 can report for a
given destination. (Range: 1–4.)
command overrides any interface-level passive mode
settings.
OSPFv3 does not form adjacencies on passive interfaces
but does advertise attached networks as stub networks.
Exit to Global Configuration mode.
Exit to Privileged EXEC mode.
View OSPFv3 global configuration and status.
Reset specific OSPFv3 states. If no parameters are
specified, OSPFv3 is disabled and then re-enabled.
distance
variable is 1–255. Lower route