Installing The Bbu In The Holder; Installing The Bbu Holder Into The Chassis; Connecting The Bbu Cable To A Controller - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

V
CAUTION!
Make sure that the connector side with the three dots is on the top (see
close-up). Otherwise you risk short-circuits.
9.5.3.3

Installing the BBU in the holder

Figure 116: Installing the BBU in the BBU holder
Ê At a slight angle, fit the BBU under the right retaining bracket on the BBU
holder (1).
Ê Fold down the BBU until it locks in place (2).
9.5.3.4

Installing the BBU holder into the chassis

Ê Install the BBU holder into the chassis as described in section
FBU holder into the chassis" on page
9.5.3.5

Connecting the BBU cable to a controller

Ê If applicable, install a RAID controller as described in section
expansion cards" on page
Ê Connect the BBU cable to the RAID controller.
TX140 S2
176.
Upgrade and Maintenance Manual
Expansion cards and backup units
193.
"Installing the
"Installing
197