Link Aggregation Configuration Example - H3C S3100-52P Operation Manual

Operation Manual – Link Aggregation
H3C S3100-52P Ethernet Switch
Clear
about a specified port or
port range

1.4 Link Aggregation Configuration Example

I. Network requirements
Switch A connects to Switch B with three ports Ethernet1/0/1 to Ethernet1/0/3. It is
required that incoming/outgoing load between the two switches can be shared
among the three ports.
Adopt three different aggregation modes to implement link aggregation on the
three ports between switch A and B.
II. Network diagram
Figure 1-1 Network diagram for link aggregation configuration
III. Configuration procedure
The following only lists the configuration on Switch A; you must perform the similar
configuration on Switch B to implement link aggregation.
1) Adopting manual aggregation mode
# Create manual aggregation group 1.
<H3C> system-view
[H3C] link-aggregation group 1 mode manual
# Add Ethernet1/0/1 through Ethernet1/0/3 to aggregation group 1.
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] port link-aggregation group 1
[H3C-Ethernet1/0/1] interface Ethernet1/0/2
[H3C-Ethernet1/0/2] port link-aggregation group 1
[H3C-Ethernet1/0/2] interface Ethernet1/0/3
Operation
reset
LACP statistics [ interface interface-type
interface-number
interface-type
interface-number ] ]
Chapter 1 Link Aggregation Configuration
Command
lacp statistics
[ to
1-12
Description
Execute the reset
command in user view.