Left Engine Crankcase Cover Assembly; Ignition Cover Removal/Refitting - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
2
1
1
1
3
3
1
1
3
4
GENERAL ENGINE PROCEDURES

Left engine crankcase cover assembly

- Clean the sealing faces and fit a new gasket.
- Turn the water pump impeller until the transmission sprocket mates correctly.
- Tighten the screws (1) replacing the sealing ring (2).
- Check that the broaching of the clutch disengagement shaft mates properly
with the clutch centre pin.
- Mount the screws (3) with the washers.
Screw in screws (1) and (3) to torque in two steps and in a cross
H11755
pattern.
H11756

IGNITION COVER REMOVAL/REFITTING

- Remove the screws (1).
- Remove the cover (2) with its gasket and be careful of the washer (3) (arrow)
and of the bushing (4), because they may stick to the cover.
2
1
H11763
H11757
F1.7
Workshop Manual Ed.09-2012