Cylinder Head Gasket Selection Chart - Husqvarna TE 250 Workshop Manual

CYLINDER HEAD GASKET SELECTION CHART

Position the piston to T.D.C. at the end of the compression stroke, measure the distance "A" between piston crown and cylinder head
face then choose the gasket as shown in the table below.
CONDITION (see picture)
1) (piston lower than cylinder head face)
2) (piston aligned with cylinder head face)
3) (piston projecting from cylinder head face)
CONDITION (see picture)
1) (piston lower than cylinder head face)
1) (piston lower than cylinder head face)
1) (piston lower than cylinder head face)
ENGINE REASSEMBLY
250
"A"
-0.1 ± 0.05 mm
0 ± 0.05 mm
0.1 ± 0.05 mm
450-510
"A"
-0.6 ± 0.05 mm
-0.5 ± 0.05 mm
-0.4 ± 0.05 mm
H.46
gasket thickness
0.7 mm
0.8 mm
0.9 mm
gasket thickness
1.0 mm
1.1 mm
1.2 mm
Part. N. 8000 B0148 (02-2008)
gasket code
8A00 A5462
8000 A5462 (STD)
8B00 A5462
gasket code
8E00 A4195
8B00 A4195 (STD)
8H00 A4195