CYLINDER HEAD GASKET SELECTION CHART
Position the piston to T.D.C. at the end of the compression stroke, measure the distance "A" between piston crown and cylinder head
face then choose the gasket as shown in the table below.
CONDITION (see picture)
code
1) (piston lower than cylinder head face)
2) (piston aligned with cylinder head face)
3) (piston projecting from cylinder head face)
CONDITION (see picture)
1) (piston lower than cylinder head face)
1) (piston lower than cylinder head face)
1) (piston lower than cylinder head face)
ENGINE REASSEMBLY
310
"A"
-0.1 ± 0.05 mm
0 ± 0.05 mm
0.1 ± 0.05 mm
450-510
"A"
-0.6 ± 0.05 mm
-0.5 ± 0.05 mm
-0.4 ± 0.05 mm
H.44
gasket thickness
0,7 mm
8A00 H0504
0,8 mm
8000 H0504 (STD)
0,9 mm
8B00 H0504
gasket thickness
1.0 mm
1.1 mm
8B00 A4195 (STD)
1.2 mm
Part. N. 8000 H1344 (10-2009)
gasket
gasket code
8E00 A4195
8H00 A4195