h/p/cosmos 150/50 locomotion de med Operating Instructions And Service Manual page 94

OP90 Load or save default settings
[6.B1]
OP91 Total time of operation MCU (h)
= total time of switch on MCU
OP92* Total distance (km)
© 2008 h/p/cosmos sports & medical gmbh
file: n:\article\cos14310m5-v1.04hpc-en\20080901_cos14310m5-v1.04hpc-en_manual_h-p-cosmos_running_machine.doc
email@h-p-cosmos.com
With this option all option values (exceptions see below) can be saved
or reloaded.
a d
With or the loading or saving is selected. After confirmation with
c
the safety request has to be confirmed again with
§
SAVE
ArE
SAV
LOAD
ArE
LOAd
If default values are supposed to be loaded without having been saved
before following message will appear and no change can be
performed.
nO d
The key SW1 on the MCU 5 assembly board performs the same action
as the loading of default values with the following exception: if there
are no default values saved, the default values of the firmware will be
taken over.
Following option values are not handled as default values and remain
unchanged:
User - OP 02: Total distance
User - OP 03: Total time of operation
User - OP 04: Total time of use
Administrator-OP 10: Treadmill serial number
Administrator-OP 91: MCU total time of operation
Administrator-OP 92: Total distance
Administrator-OP 93: Total time of operation
Administrator-OP 94: Total time of use
Administrator-OP 95: MCU serial number
§ $
and report: hours of operation
%
reports: h
This value can not be changed!
§ $
and report: total distance in km
%
reports km
Difference to user option 02: the displayed value can also be changed.
created 01.09.2008 printed 08.10.2008
optional settings
c
.
$ %
dEF AULt
YOU SUrE
Ed
dEF AULt
YOU SUrE
Ed
EF S AVEd
page: 94 of 176