h/p/cosmos 150/50 locomotion de med Operating Instructions And Service Manual page 25

Other sizes available on request.
N
For models without leveling sockets please make sure that the floor condition is even and horizontal. The machine
stands with the entire ground frame on the floor.
N
Models with a running surface of 200 x 75 cm or bigger: Make sure the floor condition is even and horizontal. The
machine stands with the entire ground frame on the floor. There are leveling sockets incorporated, but they should
only be used in case of problems with and uneven floor.
N
Before you switch on the device you need to de-install the mechanical transportation fuse, fixing the upper and
lower frame.
N
The bearing capacity of floor and ceiling in the building must be higher than the weight of the machine. It has to be
approved for the h/p/cosmos device by an authorized body of the operator. Example h/p/cosmos saturn 4.0
300/100r: Dimensions ground frame running machine: L: 3400 mm x B: 1490 mm = 5.066 m² platform. Net weight
of running machine: 1300 kg, static bodyweight of subject: 200 kg, dynamical weight of subject: 1200 kg (up to 6
times the bodyweight), over all weight load of system at platform: 2500 kg = bearing capacity of platform: 493.48
kg (~ 500 kg) / m².
N
At h/p/cosmos gaitway with integrated force plate the transportation locks have to be removed after erection. Drive
elevation up to max of 25 %. Loosen the four M8 screws, indicated with the red arrows at the underside of the alu-
force plates and remove them. Drive elevation down to 0 %. Loosen the locknuts at the levelling sockets. Now
level out the running machine with the help of the Kistler Software and then tighten the locknuts again.
N
The running belt has to be checked and if necessary adjusted (see maintenance instructions), so that it is placed
exactly in the middle of the two rollers, after installation or change of location.
N
If the running machine is installed safely and horizontal, it can be plugged in (see installation instructions) and
taken into operation.
N
It is recommended to lubricate the running surface with 40ml Silicone-Oil before using it for the first time. See
separate chapter "maintenance".
© 2008 h/p/cosmos sports & medical gmbh
file: n:\article\cos14310m5-v1.04hpc-en\20080901_cos14310m5-v1.04hpc-en_manual_h-p-cosmos_running_machine.doc
email@h-p-cosmos.com
installation & commissioning
created 01.09.2008 printed 08.10.2008 page: 25 of 176