h/p/cosmos 150/50 locomotion de med Operating Instructions And Service Manual page 85

OP08 Heart Rate Display Interval
[6.B1]
OP09 Test of all displays and LEDs
OP10 Enter the serial number of the device
according to the nameplate
OP11 Activating and de-activating speed
measurement
OP12 Setting of allowance for speed-signal-
comparison (Measurement / Control)
These values do not reflect the real
speed accuracy of the running belt.
Accuracy of running-belt speed is higher.
© 2008 h/p/cosmos sports & medical gmbh
file: n:\article\cos14310m5-v1.04hpc-en\20080901_cos14310m5-v1.04hpc-en_manual_h-p-cosmos_running_machine.doc
email@h-p-cosmos.com
§
indicates: Heart Rate Display Interval in seconds
Einstellbereich: 0 (beat to beat) .... 1 bis 9 Sekunden
Adjustable from 0 (beat to beat) .... to 9 seconds
Compare: An original POLAR watch has a display interval of 5
seconds
$
reports: SEC
Change the values with a or d
Confirm the values with c
Example: Treadmill with serial number cos30000va08-0128 on the
nameplate
§
reports: 300 (item number of device)
$
indicates: 0008 (item number of device)
%
indicates: 0128 (consecutive serial numbers of this device
family)
Normally the speed measurement is activated / de-activated by
selecting the correct device type (administrator option number 3). Only
in very special cases a special adjustment in option number 11 is
necessary. Speed measurement can only be activated if the device
has a speed sensor
§
reports:
0 = without speed measurement / -sensor
1 = with speed measurement / -sensor
(permanent control)
2 = with speed measurement / -sensor
(control as of speed > 2 km/h, no control < 2km/h)
The MCU5 control unit is comparing continuously the data of the
speed measurement with a calculated reference value. In order to
detect problems with the speed measurement or speed control or e.g.
performance limitations due to a bad voltage supply, an allowance
range can be set in this option. In case the allowance is exceeded the
error message E.31 (measured speed is too high) or E. 32 (measured
speed is too low) is reported.
§
reports: OFF = no comparison
6 = 6 % deviation is allowed
8 = 8 % deviation is allowed
10 = 10 % deviation is allowed
created 01.09.2008 printed 08.10.2008
optional settings
page: 85 of 176