[5.B4] Automatic Mode; [5.B5] Profile Mode / Pre-Programmed Training Profiles - h/p/cosmos 150/50 locomotion de med Operating Instructions And Service Manual

[07] Switch over to the next mode or
[5.B3]
one mode back
[08] Stop running belt
Automatic mode
[5.B4]
The automatic mode is for starting a training profile, a heart rate dependant speed control or a test profile.
Caution: The treadmill belt will start moving automatically and the speed and elevation will be changed
automatically after one of the 3 modes (profile, cardio, test) has been started. You and all other users need to get
familiar with the details and risks of these modes (e.g. the max. speed and elevation of these modes) for not facing
the danger of too high speeds and injuries.
Additionally there is the possibility to disable each mode (manual, profile, cardio, test) in the user-option-mode (see
chapter "optional settings". This can be required in special cases for additional safety or to reduce functions of
more simple operation.
N
Automatic operation (mode profiles, cardio, test, remote control via PC and peripheric
devices) is forbidden, if the health and the condition of the test person / patient do not
allow them and a doctor has not authorized these loads. Disregard may cause injuries and
dangerous health problems.
N
At automatic operation the test person / patient and supervisory staff have to impropriate
exact knowledge about the expected loads before starting and anticipate an automatic
load alternation (speed, acceleration, decelaration, elevation and STOP) at any time. It is
necessary to meet the appropriate higher and reasonable safety precautions.
Profile Mode / Pre-programmed training profiles
[5.B5]
Profile-mode offers 6 different programs, which, with the help of various speed and elevation combinations,
simulates easy running training as well as a cross-country run.
In case of activation (standard deactivated) in the user-options (OP11): The maximum speed, maximum elevation
and the duration of the 6 profiles can be selected ("scaled"), in order to provide 6 x 6 x 6 (216 total) variations of
profiles. Standard set-up is without scaling, for quicker and easier access.
All of the 6 profiles are predefined and cannot be changed in the memory. For creating your personal profile:
Test No 21 ... 28 are user defined (free programmable Profiles).
For a better and easier documentation we recommend to use the serial printer interface or to connect an external
PC in order to use the h/p/cosmos para graphics
© 2008 h/p/cosmos sports & medical gmbh
c
and simultaneous
a
or
b
®
file: n:\article\cos14310m5-v1.04hpc-en\20080901_cos14310m5-v1.04hpc-en_manual_h-p-cosmos_running_machine.doc
email@h-p-cosmos.com
Switch (Jump) over to the next Mode, or jump to the
previous Mode. This is a perfect way to change to other
Modes without stop of the belt.
d
Running-Belt stops.
(Deceleration time can be adjusted in the optional
functions)
Display values and pre-selected mode remain for 2
minutes and will then be deleted (reset) automatically
for documentation.
created 01.09.2008 printed 08.10.2008
operation
page: 43 of 176