[5.B6] Possibilities Of Interfering Into The Profile Mode Manually - h/p/cosmos 150/50 locomotion de med Operating Instructions And Service Manual

Possibilities of interfering into the profile mode manually
[5.B6]
A Profile can be changed on-line, but not in the memory location. For personal profiles use test-profiles no. 21 – 24
Initiation: Operational mode: Profile, running-belt is moving.
Step no. Activity
[5.B6]
[01] Alteration of speed
[02] Alteration of acceleration and
deceleration of speed
[03] Pause Mode = Interfere a
program step
[04] Alteration of elevation
[05] Switch over to the next program
step or one program step back.
[06] Switch over to the next mode or
one mode
For a better documentation we recommend to use a printer linked to the serial interface or/and to use an external PC with the
Software h/p/cosmos para graphics
© 2008 h/p/cosmos sports & medical gmbh
Keys
a
or
press and hold
c
press several times
and then hold
a
f
or
press and hold
c
and simultaneous
e
or
c
and simultaneous
a
or
®
.
file: n:\article\cos14310m5-v1.04hpc-en\20080901_cos14310m5-v1.04hpc-en_manual_h-p-cosmos_running_machine.doc
email@h-p-cosmos.com
Response / Display
d
Speed is being increased / reduced (0-max.) as long as
the key get pressed. If SPEED is being reduced down to
„0" = PAUSE-position. Current values will be sustained.
Alteration of the speed is only online for this single step.
The speed can not be changed in the memory. Next
program step as in the profile definied.
Example: For acceleration or deceleration level "3",
press 3 times the corresponding key and then hold.
Note: Maximum 7 levels, limited by the maximum
acceleration level selected in the Optional Mode /
standard value = 4.
=
indicates: "PAUS". Running belt stops. All
displays stop. Current values will be sustained.
When restart with d or c all display values will be
added.
e
Elevation is being increased / reduced (0-max.) as long
as the key get pressed.
Alteration of the elevation is only online for this single
step. The elevation can not be changed in the memory.
Next program step as in the profile definied.
Jump over to the next program step, or jump to the
previous program step.
f
Jump over to the next mode, or jump to the previous
Mode. This is a perfect way to change to other modes
without stop of the belt. For example to start manual
d
mode for a "cool-down" period without stop of the belt
created 01.09.2008 printed 08.10.2008
operation
page: 45 of 176