Master Cylinder - Honda SXS700M4 Service Manual

BRAKE SYSTEM
MASTER CYLINDER
REMOVAL/INSTALLATION
Drain the brake fluid (page 20-6).
When removmg the
jomt nut. covar the
ends of the brake
pipes to prevent
brake fluKJ lea kage .
Insert
the
bolts
from
the pedal
side.
Be
careful
not
to
cross-thread the
Remove the clip (1J and joint pin [2] to disconnect the
push rod (31.
Loosen the joint nuts [4] to disconnect the brake pipes
151·
Remove the two mounting nuts [6J. bolts [7J and master
cylinder [61 from the frame .
Install the master cylinder with the mounting bolls and
the nut. aligning the push rod slit with the brake pedal.
Connect the brake pipes to the master cylinder with the
joint nuts.
joint nuts.
Tighten the mounting nuts. then tighten the jOint nuts.
20-12
TORQUE :
Mounting nut 27 N'm (2.8 kgf' m , 20 IbHt)
Brake p ipe joint nut: 14 N'm (1.4 kgf'm , 10 Ibf-ft)
Connecllhe push rod 10 the pedal wilh the joint pin and
secure il with the clip.
Check the brake pedal height (page 3-16).
Fill and bleed the hydraulic system (page 20-7).
17]
4
111
121
131