Accessory Socket - Honda SXS700M4 Service Manual

LIGHTS/METERS/SWITCHES
3. Speedometer Line Open Circuit Inspection
Disconnect the combination meter sub harness lOP
(gray) connector (page 22-5),
Disconnect the VS sensor 3P connector [I ) (located
on the rear final drive gear case).
Check the Pink wire for continuity between the
combination meter sub harness tOP (gray)
connector and VS sensor 3P connector terminals.
Is there continuity?
YES - Replace the combination meter
(page 22-4).
NO Open circuil in the Pink wire .
loose or poorly connected
related
connectors.
ACCESSORY SOCKET
INSPECTION
22-8
Remove the front hood (page 2-12).
Disconnecllhe accessory socket 2P (green) connector
11 J.
Measure the voltage between the Whitelblack (+) and
Green (-) wire terminals of the wire harness side 2P
(green ) connector.
There should
be
battery voltage with the ignition switch
turned to
ON
(I).
If there
is no voltage, check for blown ACC fuse (10 A)
and an open drcuit in the wire harness.
Remove the accessory socket cap
[1].
Check for continuity between the White/black wire
terminal of the socket side
2P
(green) connector and
bottom
center terminal
121
of the socket, and between
the Green wire terminal and side wall terminal
[3].
There should be continuity.
If there is no continuity, check the sub harness for open
circuit.
If the sub harness is OK, replace the accessory socket.
Pink
-@
Pink