Service Information - Honda SXS700M4 Service Manual

FUEL SYSTEM
SERVICE INFORMATION
GENERAL
Before disconnecting the fuel feed hose, relieve pressure from the system (page 7·5).
Bending or twisting Ihe control cable will impair smooth operation and could cause the cable to stick or bend , resulting in loss of
vehicle control.
Work In a well ventilated area. Smoking or allowing flames or sparks in the work area or where gasoline is stored can cause a
fire or explosion.
Do not snap the throttle valve from full open to full dose after the throtl1e cable has been removed.
1\
may cause incorrect idle
operation .
Seal the cylinder head intake port with tape or a clean cloth to keep dirt and debris from entering Ihe intake port after the throttle
body has been removed.
Do
not damage the throttle
body.
II may cause incorrect throtlle valve operation.
Prevent dirt and debris from entering the throttle bore, IACV, sensor hole and fuel feed hose , clean them using compressed air.
The throttle body is factory pre·set. Do not disassemble in a way other than shown in this manual.
Do not loosen or tighten the white painted bolts, nuts and screws of the throWe body. Loosening or tightening them can cause
throttle body malfunction.
TOOLS
Fuel pressure gauge
07406"()040004
or 07406..Q04000C (U.S.A . only)
or 074()6...{)04000B (U.S.A . only)
Adaptor, male
07AAJ·S6MA200 (U.SA only)
Fuel connector remover
070MF·HP50200
7-4
Pressure gauge manifold
07ZAJ·S5A0111
Not available in U.S A .
Adaptor, female
07AAJ·S6MMOO (U.S.A . only)
Hose attachment. 9 mm/9mm
07ZAJ·SSA0120
Not available in U.S.A .
Pressure manifold hose
07AMJ-HW3A100 (U.SA only)
•
•
•