Crankcase Assembly - Honda SXS700M4 Service Manual

CRANKCASE/CRANKSHAFT/BALANCER
Apply engine oil to new bearings [1).
Drive the bearings in with the marks facing up.
TOOLS:
Balancer Bearing
Driver [2]
07749-0010000
AttaChment, 37 x 40 mm [3]
07746-0010200
Pilot, 17 mm (4) 07746-0040400
Mainshaft Bearing
Driver
07749-0010000
Attachment, 62 x 68 mm 07746-0010500
Pilot, 35 mm 07746-0040800
The countershaft
Countershaft Bearing
bearing is installed
Driver
07749-0010000
with the sealed side
Attachment, 42 x 47 mm 07746"()010300
facing down.
Pilot, 20 mm
07746-0040500
Crankshaft Bearing
Driver
07749-0010000
Attachment, 78 x 90 mm
07GAD-SD40101
CRANKCASE ASSEMBLY
Before installing the front crankcase cover, make sure
the gear side surfaces (Cl and Ml gears [1]) of the
countershaft [21 and mainshaft [3] are flush .
Clean the fron t and rear crankcase mating surfaces .... - --
thoroughly, being careful not to damage them.
Blow through the oil passages in the crankcases wi th
compressed air.
"" .......
..,.j
Coat new O-rings [1] with engine oil and install them
into the joint collar grooves. Install the oil joint coUar [2J
into the crankcase.
14-11