Honda SXS700M4 Service Manual page 449

INSTALLATION
Route the brake
Install upper arm [1] and lower arm {2] into the frame
hose property
with the pivot bolls [3] and new nuts [4] , and loosely
(page
1-1 7). lighten them .
Insett all/he bolts
from the fronl side.
Install the wheel hub/knuckle assembly onto the drive
shaft and arms, and install the ball joint nuts [lJ and
washers [21 .
Tighten each nut to the specified torque and further
tighten until its grooves align with the cotter pin hole.
TORQUE: 29 N 'm (3.0 kgf'm , 21 IbHt)
Install new cotter pins
Pl.
Adjust the suspension arm angle with a jack supporting
the lower arm so that the distance between the centers
of the shock absorber mounting bolt holes is 440 - 448
mm
(17.3 -17.6
in).
After adjusting the angle. lighten all the upper and lower
arm pivot fasteners to the specified torque.
TORQUE (Upper and lower):
34 N·m (3.5 kgf·m, 251bHt)
Tighten
WHEEUSUSPENSION
440 -448 mm
(t7.3-17 .6 in )
Support
19·19