Honda SXS700M4 Service Manual page 327

Install the two dowel pins [1J.
Make sure fhe
Install the front crankcase cover [1].
mating surfaces
Install the fourteen bolts [2] and tighten them in a
touch evenly. There
crisscross pattern in several steps.
Should be no
clearance between
the cover and
crankcase.
Coat a new O-ring [1] with engine oil and install it onto
the flange of the feed pipe B [2].
Apply engine oil to the outer surface of pipe 8.
Align the nange tabs
Carefully insert the feed pipe B while turning it slowly to
with the grooves in
avoid damaging the oil seal in the crankcase.
the cover.
Coat new O-rings [1] with engine oil and install them
into the setting collar [21 grooves.
Install the setting collar until it is seated.
DRIVETRAIN SYSTEM
16-39