Honda SXS700M4 Service Manual page 373

DRIVE SHAFT/FINAL GEAR
Each boot [1J has following identification number [2J. Do
not interchange them. [1)
FRONT DRlVE SHAFT BOOT:
INBOARD BOOT: 519-75
OUTBOARD BOOT : 98·71 L
REAR DRIVE SHAFT BOOT:
INBOARD BOOT : 672·75L
OUTBOARD BOOT : 98·71 L
Note the installation direction of the boot bands [11.
Each band has following identification number [21. Do
not interchange them.
FRONT DRIVE SHAFT BAND :
INBOARD SHAFT BOOT BAND: 25
INBOARD BOOT BAND: 68
OUTBOARD SHAFT BOOT BAND : 24
OUTBOARD BOOT BAND : 69
REAR DRIVE SHAFT BAND :
INBOARD SHAFT BOOT BAND : 25
INBOARD BOOT BAND : 72.5
OUTBOARD SHAFT BOOT BAND : 24
OUTBOARD BOOT BAND: 69
Pack Ihe outboard joint with the specified grease.
SPECIFIED GREASE :
Front/rear: NKG708
AMOUNT:
Front/rear: 45 - 65 g
Install the following:
- outboard boot 11]
- new shaft boot bands [2]
- inboard boot [3]
Do not tighten the bands at this time.
121
Forward rotation direction
[1[
c: - 0:>
[11
Install the bearing [11 with the small 0 .0. facing the
~==~------------==~
drive shaft.
Install the snap ring [2] with the chamfered side facing
the bearing.
[1[
18-11