Ignition Switch - Honda SXS700M4 Service Manual

REMOVAL/INSTALLATION
Remove the front hood (page 2-12).
Disconnect the 2P (black) connector [1J from the
accessory socket.
Remove the accessory socket nut [2] .
Remove the accessory socket (1J from the instrument
panel.
tnstali l he accessory socket by aligning the lug with the
groove
in the instrument panel.
Install the removed parts in the reverse order of
removal.
IGNITION SWITCH
INSPECTION
Remove the front hood (page 2-12).
Disconnect the ignition switch 5P (black) connector [1].
Check for continuity between the connector terminals in
each switch position according to the continuity chart
(page
23-2).
REMOVAL/INSTALLA nON
Disconnect the ignilion switch 5P (black) connector
(page
22-9).
Remove the ignition switch nut [1) and ignilion switch [2]
from the instrument panel.
Install the ignition switch into the instrument panel by
aligning the fla t surfaces.
Inslallthe ignition switch nut and tighten it.
TORQUE : 4.9 N·m (0.5 kgf·m , 3.6
IbHt )
Connect the ignition switch 5P (black) connector.
Install the front hood (page 2.12).
LIGHTS/METERS/SWITCHES
[2J
(1/
11J
22·9