Final Gear Case Assembly - Honda SXS700M4 Service Manual

Keep dust and din
out of the case and
cover.
DRIVE SHAFT/FINAL GEAR
FINAL GEAR CASE ASSEMBLY
NOTE :
When the gear set. bearing, differential andlor gear
case has been replaced , check the tooth contact
pattern (page 18-32) and check the gear backlash
(page 18-30).
Clean the mating surface of the gear case and cover,
being careful not to damage them.
Blow compressed air through the breather hole in the
case cover.
Install the proper ring gear shims [1) onto the differential
~::::'111111111111111~~~~~~111111111111=~
assembly. [1J
Inslall the differential assembly (1) into Ihe gear case ___
{2{.
ll'iW
~~
Coat a new O-ring [3} with grease and install
it
into the [3]
case cover groove.
Install the case cover (4] over the gear case.
141
{11
121
18-41