Dtc 33-2 (Eeprom); Dtc 64-1 (Drive Power Low Voltage) - Honda SXS700M4 Service Manual

DTC 33-2 (EEPROM)
1. Recheck DTC
Erase the DTC (page 4-8).
Turn the ignition switch to OFF (0) and ON (I).
Recheck the peM EEPROM with the MeS.
Is DTe 33-2
indicated?
YES - Replace the peM with a known good one
and recheck.
NO - Intermittent failure
DTC 64-1 (DRIVE POWER LOW
VOLTAGE)
Before starting the troubleshooting, check thai the
battery and IGN fuse (15 A) are in good condition.
1. Recheck OTC
Erase the DTG (page 4-8).
Turn the ignition switch to OFF (0) and ON (I).
Recheck the DTG with the MeS.
Is DTe 64-1 indicated?
YES - GO TO STEP 2.
NO - Intermittent failure
2. Drive Power Input Line Inspection
Turn the ignition switch to OFF (0).
Disconnect the PCM 5P (black) connector (1].
Turn the ignition switch to ON (I).
Measure the voltage between the wire harness side
5P
(black) connector terminal and ground.
Connection : BlackJred
(+) -
Ground (-)
Is there battery voltage?
YES - Replace the PCM with a known good one
and recheck.
NO - GO TO STEP
3.
3.
Main Relay Inspection
Check the main relay (page
7~ 13) .
Is the main relay normal?
YES - GO TO STEP 4.
NO - Faulty main relay
4. Main Relay Circuit Inspection
Check the main relay circuits (page
7~13).
Are the main relay circuits normal?
YES - Open circuit in the Black/red wire
NO - Faulty main relay circuit(s)
PGM-FI SYSTEM
(11
\
Black/red (+)
4-23