Front Final Gear Disassembly/Inspection; Backlash Inspection - Honda SXS700M4 Service Manual

DRIVE SHAFT/FINAL GEAR
Install the steel ball [ 1] and stopper spring [2] .
InslaUthe spring plug [3J with a new sealing washer [4]
and lighten
it.
TORQUE: 21.6 N'm (2.2 kgf'm, 16 1bHt)
Install the differenl iallock switch [5] with a new sealing
washer (6) and tigh ten it.
TORQUE: 12 N'm (1 .2 kgf'm, 9lbHt)
Check the differential lock clutch operation
(page
18-16).
FRONT FINAL GEAR OISASSEMBL VI
INSPECTION
Remove the following:
- final clutch housing (page 18-19)
- differential lock clutch housing (page 18-25)
BACKLASH INSPECTION
Set the final gear case into a jig or vise with soft jaws.
Remove the oil filler cap.
Cover fhe clutch
Hold the pinion gear with the special tools.
housing mating
surface
WIth
TOOLS:
protective tape or
Pinion puller base (1J
en equiYalent to
Puller shaft and nut [2]
prevent damaging
Threaded adaptor [3J
18-30
if.
U.S.A.
TOOLS :
Pinion puller base
Puller shaft
Special nut
Threaded adaptor
07HMC·MM80110
07965·VM00200
070MF·HP50100
07HMC·MM8011A
07931·ME4010B
07931·HB3020A
070MF·HP5A100
111 161
151
•