Front Fender; Front Door Panel Removal/Installation - Honda SXS700M4 Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
FRONT FENDER
REMOVAUINSTALLATION
Remove the fronl grille (page 2-12).
Righfsideonly."
Release the fuse box [1]. relay base [2J and headlight
sub harness 2P (black) connector [3].
Left
side
only:
Release the combination meter sub harness 10P (gray)
connector
[4]
and headlight switch 2P (black) connector
(5(.
DOOR
Remove the following:
fronl side cover socket boll [1]
four clips {2]
- three special bolts [31
fronl fender [4]
Installation is in the reverse order of removal.
TORQUE :
Front side cover socket bolt:
9 N'm (0 .9 kgf'm, 6.6 IbHt)
FRONT DOOR PANEL REMOVAU
(NSTALLATION
Open the door.
Support the bottom of the fron t door panel [1].
Remove the four socket bolts [2J and the door panel.
Close and latch the
Installation is in the reverse order of removal.
door before
lightening the bolts.
TORQUE :
Front door hinge socket bolt:
30 N'
m (3.1 kgf-m, 22Ibf·ft)
After installation, make sure the door latches securely
without requiring excessive force and opens smoothly.
If necessary, loosen the socket bolts and adjust the
door panel position.
If the door rallies when closed, turn the door stopper {3]
rubber so that the door latches on the second click.
LeftSid ~
(41
(1
I
~
~.
.
(21
(41
(3~
(1 I
."
(21
(21
(1
I
(51
2-13