Table of Contents
Advertisement
Be
sure
that the
vehicle is
level with
the wheels on the
radius gauges and
boards.
SIDE NET
TURNING RADIUS INSPECTION
Raise
the
vehicle off the ground, set the
turning
radius
gauges
[lJ
beneath the front wheels and place boards
(that are the same height as the radius gauge) under
the
rear
wheels,
then
lower the vehicle.
Apply the parking brake.
Set the drive mode selector lever
to
the
"2WO"
or
"4WD"
position to free the differential
lock.
Turn the wheels
left
and right with no foot
brake
applied. and measure the turning radius angle of both
wheels.
TURNING
RADIUS
ANGLE:
Inward
:
41
"
Outward
: 33°
(reference)
If
the
measurements are not to specification, even up
both sides of the tie-rod [2] thread length while
adjusting
the toe
(page
3-22).
Check the side net [1] webbing
for tear
or damage.
Visually inspect
the
snap hooks (2), buckle [3) and side
net rings
(4)
for wear or damage and replace the side
net assembly if necessary.
Measure the snap hook thickness.
SERVICE
LIMIT:
6.0
mm
(0
.24 in)
If
it
is less than the service limit, replace the side net
assembly.
MAINTENANCE
111
Front shown:
12)
3-23
Advertisement
Table of Contents
Troubleshooting
