Ignition System Inspection; Peak Voltage Adaptor Connection; Ignition Coil Primary Peak Voltage - Honda SXS700M4 Service Manual

IGNITION SYSTEM INSPECTION
PEAK VOLTAGE ADAPTOR
CONNECTION
NOTE :
If there is no spark al the plug. check all connections
for loose or poor contact before measuring the peak
vol tage.
Use a commercially available digital multimeter with
an impedance of 10 MO/DCV minimum.
The display value differs depending upon the
internal impedance of the multimeter.
If the peak voltage lester (U.S.A. only) is used ,
follow the manufacturer's instructions.
IGNITION SYSTEM
Use the peak voltage tester or connect the peak voltage
,-----------------~
adaptor [1J to the digital multimeter
[21 .
TOOLS :
IgnitionMate peak vol tage tester MTP07-0286
(U.S.A. only) or
Peak voltage adaptor 07HGJ-0020100
(Not available in
U.S.A.)
with commercia lly available digital muttimeler
(impedance 10 MOJOCV minimum)
IGNITION COIL PRIMARY PEAK
VOLTAGE
NOTE:
Check all system connections before this inspection .
Poor connected connectors can cause incorrect
readings.
Check the cylinder compreSSion and check that the
spark plug is instal led correctly in the cylinder head.
Remove the front seat cushion (page 2-4).
4 person type only:
Remove the left rear foot well (page 2-10).
Disconnect the spark plug cap {1] from the spark plug.
Connect a known-good spark plug {2] to the spark plug
cap and ground the spark plug to the cylinder head as
done in a spark test.
12]
\
r
v
111
12]
~I
\
5-5