Fuel Injector - Honda SXS700M4 Service Manual

FUEL SYSTEM
Install the retainer plate [1] by aligning the groove with
the valve boss.
Install and tighten the two torx screws [2].
TORQUE : 2.1 N'm (0.2 kgf-m, 1.5IbHt)
Connect the IACV 4P (black) connector [3].
Install the left middle fender (page 2-8).
FUEL INJECTOR
REMOVAL/INSTALLATION
Relieve the fuel pressure (page 7-5).
Disconnect the quick connect filting from the fuel
injector (page 7-5).
Clean around the fuel injector base with compressed air
before removing the fuel injector, and be sure that no
debris is allowed to enter into the combustion chamber.
Disconnect the fuel injector 2P (gray) connector [1] and
IACV 4P (black) connector [2].
Remove the two mounting bolts [3] and the fuel injector
assembly
14]
from the throttle body.
Remove the following:
- injector joint ]1]
- joint rubber ]2]
- a-ring [3]
- fuel injector [4]
- seal ring [5]
Apply engine oil to new seal ring and a-ring and install
them onto the fuel injector.
Install a new joint rubber.
st'D
[5)
[1 )
[4[
Install the injector joint [1] onto the fuel injector [2] with
~=================~
the stopper [3] facing the connector as shown, being
careful not to damage the O-ring.
[3)
[1)
7-24