Steering Wheel; Steering Column And Shaft - Honda SXS700M4 Service Manual

STEERING SYSTEM
STEERING WHEEL
REMOVAL/INSTALLATION
MarX tile
steering
Remove the following:
wheel and shaft
- center cover 11] (by releasing Ihe three hooks from
before removing to
identify its original
position.
Ihe steering wheel)
- nut 12l
- steering wheel
[3]
- dust seal/collar 1 4]
Installation is in the reverse order of removal.
TORQUE:
Steering wheel nut:
49
N'm (5.0 kgf' m , 361bHt)
Apply grease to the dust sealfcollar
lips.
Check Ihe condition of dust seal/collar and replace
if
necessary.
STEERING COLUMN AND SHAFT
REMOVAL
17-4
Remove the following:
- steering wheel (page 17-4).
- left front fender (page 2-13)
Raise Ihe front wheels off the ground.
Remove the upper pinch bolt
11]
and lock washer (2).
Remove Ihe lower pinch bolt {3] and lock washer [4].
Lower Ihe steering shaft 15J and disconnect
it
from the
column shaft [6J, then remove it from the steering pinion
[71.