Honda SXS700M4 Service Manual page 141

Install the brush holder [I]. aligning the holder tab with
Ihe case groove, and the holder grooves with the
insulated brush wires.
Push and hold the brushes inside the brush holder, and
install the armature [1] through the motor case and
brush holder.
When installing the armature into the motor case, hold
the armature tightly to keep the magnet of the case
trom
pulling the armature against it.
NOTICE
The coil may be damaged if the magnet pulls the
armature against the
case.
Install the same number of shims [1] in the same
location as noted during removal.
Install a new seal ring [2J onto Ihe molor case.
Apply a thin coa t of grease to the armature shaft end.
Install the rear cover [3). aligning its groove with the
brush holder tab.
ELECTRIC STARTER
Align
Install the shims
Install the shims [1) and insulated washer [2] onto the
~!~~~~~~~=:==:===~~~~
properly as noted
armature shaft.
during removal.
Install a new seal ring (3) onto the motor case.
Apply grease to the oil seal lip and needle bearing in the
fronl cover [4).
Install the lock washer [5) onto the front cover.
Install the front cover.
15)
6-7