Honda SXS700M4 Service Manual page 362

STEERING SYSTEM
17-18
Install a new pinch bolt [1] with a new lock washer
[21
and tighten it to the specified torque while supporting
the shaft to ensure that the bolt is centered vertically in
the slot.
TORQUE: 27 N'm (2.8 kgf'm , 20 IbHt)
Inslall the holder bracket PI and cover base (2) with the
two bolls [3], and tighten them to the specified torque .
TORQUE : 10 N'm (1.0 kgf-m , 1 Ibf·ft)
Instalilhe clutch arm cover [4] by aligning the slits with
the tabs [5] and tighten the boll [6] to the specified
torque.
TORQUE: 10 N'm (1 .0 kgf'm , 7lbHt)
Connect the tie-rods (page 17-9).