Honda SXS700M4 Service Manual page 259

SUB-TRANSMISSION/GEARSHIFT LINKAGE
Apply engine oil to the output driven gear (1]leelh and
set the it into the crankcase.
--"' 7 1
Insert the output shaft [2] through the driven gear and .
install
it
into the crankcase.
Install the countershaft assembly [1] by engaging the
splines.
Apply engine oil to the fork shaft [1) outer surface.
Before inslallat/OT1,
InslaUthe shift fork [2} into the gear shifter groove and
be
sure thai/he
drum guide groove with the mark SIde
facing
out.
switch pin groove
Insert
the fork shaft through the fork and Install it into
{3J in the shift
drum
the crankcase.
;s
vertICal
as
shown
'D I'I
Apply molybdenum oil solution to the reverse idle gear
~~~1ii.'iRiii~~:;;
shaft [lJ
whole
surface.
Apply engine oil to the gear teeth and needle beanngs
121·
Inslallthe following:
- gear shaft
- washer [3)
- two needle bearings
- idle gear [4]
- washer [5]
Install the rear crankcase cover (page 13·7).
13-15