Fuel Meter Inspection; Fuel Level Sensor Inspection - Honda SXS700M4 Service Manual

LIGHTS/METERS/SWITCHES
FUELMETE~FUELLEVELSENSOR
FUEL METER INSPECTION
If the fuel meier 111 indicates the blinking pattern as r - I '- J - - - - -- - - - -- - -- - - - ,
shown when the ignition switch is turned to ON, perform ' -
22-14
the following inspection . "'"
Disconnect the combination meter sub harness lOP
(gray) connector (page 22-4).
Disconnect the fuel pump 4P connector (page 7-5),
Check for continuity between the combination meter
10P
(gray) connector
12]
and fuel pump 4P connector
[3]
of
the wire harness side.
CONNECTION: White/blue - White/b lue
Light blue - Ught b lue
If there is no continuity, check for open circuit in Whilel
blue or Light blue wire and loose contact of the wire
harness connectors.
Check for continuity between the combination meier
sub harness lOP (gray) connector and ground
CONNECTION: White/blue - Ground
If there is con tinuity, check for short drcui! in Whilelblue
wire.
If the wires are
OK,
check the fuel level sensor
(page
22-14).
If the fuel level sensor is
OK,
replace the combination
meter.
FUEL LEVEL SENSOR INSPECTION
Remove the fuet pump (page
7.10).
Measure the resistance between the connector
terminals
[1]
at the float upper (full) and lower (empty)
positions.
(20 · C/B8 °FI
FLOAT FULL EMPTY
POSITION
RESISTANCE 85.3 - 101 .3 0
628.5 - 752.5
0
Replace the fuel level sensor (page
22-15)
if it is out of
specification.
12J
@
Whitelblue , - - - {
12J
1\1)
FULL
EMPTY
~
Whitel
blue
•
•
13J
Light blue
I