Stator/Ckp Sensor Removal/Installation - Honda SXS700M4 Service Manual

Rep/ace the torque
limiter
as
an
assembly.
Check the teeth of the reduction gears [1] and torque
limiter {2] for abnormal wear or damage.
Hold the torque limiter
11
J
in a vise with the special tool.
Check the slip torque with the special tool and a torque
wrench.
TOOLS :
Torque limiter attachment B
[2]
Torque limiter attachment D
[3]
STANDARD SLIP TORQUE :
07YMJ·MCF0200 (not
available in U.S.A.)
070MJ ·HN80100
(not
available in U.S.A.)
53 - 84 N' m (5.4 - 8.6 kgf'm, 39 - 62 IbHt)
STATORlCKP SENSOR REMOVAL!
[NSTALLAT[ON
ALTERNATORlSTARTER CLUTCH
[2]
Remove the CKP sensor mounting bolts [1] and release , - - - - -
the CKP sensor [2].
Remove the boll [3) and wire holder [4]. then release
the wire grommet ISJ off the alternator cover.
Remove the fou r bolts [6] and alternator stalorlCKP
sensor assembly [7] .
Install the siatorfCKP sensor assembly {1] onto the
alternator cover.
Apply sealant (Threebond T81215 or equivalent) to the
wire grommet seating surface and install the grommet
[2] into the cover groove
securely.
Install and tigh ten the four alternator stator bolts [3110
the specified torque.
TORQUE: 10 N'm (1 .0 kgf'm , 7 Ibf·ft)
Apply locking agenllo the CKP sensor bolt [4] threads,
then install and tighten them to the specified torque.
TORQUE : 6 N'm (0.6 kgf' m, 4.4 Ibf.ft)
Instal! the wire holder [5] .
Apply locking agent to the wire holder bolt [6] threads,
then install and tighten them to the specified torque.
TORQUE : 10 N'm (1 .0 kgf'm , 7lbHt)
[7]
[2]
.,(€!.!I!
I
12-7