Table of Contents
Advertisement
TJ
AUTOMATIC - 32RH (Continued)
Fig. 47 Output Shaft Thrust Washer
1 - REAR CLUTCH HUB
2 - OUTPUT SHAFT THRUST WASHER
3 - OUTPUT SHAFT
Fig. 48 Aligning Rear Clutch Disc Lugs
1 - REAR CLUTCH DISCS
2 - USE SMALL SCREWDRIVER TO ALIGN CLUTCH DISC
TEETH
(7) Raise front end of transmission upward as far
as possible and support case with wood blocks. Front/
rear clutch and oil pump assemblies are easier to
install if transmission is as close to upright position
as possible.
(8) Install front and rear clutch units as assembly
(Fig. 49). Align rear clutch with front annulus gear
and install assembly in driving shell. Be sure out-
put shaft thrust washer and thrust plate are
not displaced during installation.
2001 JEEP WRANGLER
(9) Carefully work assembled clutches back and
forth to engage and seat rear clutch discs on front
annulus gear. Verify that front clutch drive lugs are
fully engaged in slots of driving shell after installa-
tion.
1 - INPUT SHAFT
2 - FRONT CLUTCH
3 - REAR CLUTCH
FRONT BAND AND OIL PUMP
(1) Slide front band over front clutch retainer (Fig.
50).
(2) Insert front band reaction pin part way into
case (Fig. 50).
(3) Install front band lever, strut, lever pin and
adjusting screw (Fig. 51).
(4) Tighten front band adjusting screw until band
just grips clutch retainer. Verify that front/rear
clutches are still seated before continuing.
(5) Coat band lever pin access plug with sealer
and install plug in converter housing (Fig. 52).
(6) Verify that reaction shaft support hub seal
rings are hooked together (Fig. 53).
(7) Coat front clutch thrust washer with petroleum
jelly to hold it in place. Then install washer over
reaction shaft hub and seat it on pump (Fig. 54).
CAUTION: The thrust washer bore (I.D.), is cham-
fered on one side. Make sure the chamfered side is
installed so it faces the pump.
AUTOMATIC - 32RH
Fig. 49 Installing Front/Rear Clutch
21s - 101
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
