Vr4102/Vr4111 To S1D13706 Interface; Hardware Description - Epson S1D13706 Technical Manual

Page 12

4 VR4102/VR4111 to S1D13706 Interface

4.1 Hardware Description

NEC VR4102/VR4111
WR#
SHB#
RD#
LCDCS#
LCDRDY
ADD17
ADD[16:0]
DAT[15:0]
BUSCLK
Note:
When connecting the S1D13706 RESET# pin, the system designer should be aware of all
conditions that may reset the S1D13706 (e.g. CPU reset can be asserted during wake-up
from power-down modes, or during debug states).
Figure 4-1: Typical Implementation of VR4102/VR4111 to S1D13706 Interface
S1D13706
X31B-G-007-02
The NEC VR4102/VR4111 microprocessor is specifically designed to support an external
LCD controller by providing the internal address decoding and control signals necessary.
By using the Generic # 2 Host Bus Interface, no glue logic is required to interface the
S1D13706 and the NEC VR4102/VR4111.
A pull-up resistor is attached to WAIT# to speed up its rise time when terminating a cycle.
BS# (bus start) and RD/WR# are not used by the Generic #2 Host Bus Interface and should
be tied high (connected to HIO V
The following diagram shows a typical implementation of the VR4102/VR4111 to
S1D13706 interface.
).
DD
Pull-up
System RESET
HIO V
DD
Interfacing to the NEC VR4102 / VR4111 Microprocessors
Epson Research and Development
Vancouver Design Center
S1D13706
WE0#
WE1#
RD#
CS#
WAIT#
M/R#
RESET#
AB[16:0]
DB[15:0]
CLKI
BS#
RD/WR#
Issue Date: 01/02/23