Perkins New 1000 Series Workshop Manual page 358

15
Adaptor for a hydraulic pump or a steering pump with a splined drive
To remove and to fit
To remove
1 Release the cap screws and remove the adaptor assembly from the rear of the timing case.
2 Check the gear, the spline and the bearings for wear and other damage and renew the components as
necessary.
To fit
1 Fit a new "O" ring (A6) in its recess in the housing (A5) and lightly lubricate it with clean engine lubricating
oil. Lubricate the bearings (A2) and (A7) with clean engine lubricating oil. Fit the adaptor assembly to the timing
case and tighten the cap screws.
1
7
A
344
This document has been printed from SPI². Not for Resale
1
2
3
4
6 5
A0288
New 1000 Series
Operation 15-12
Workshop Manual, TPD 1350E, Issue 4