Operation 5-23 To Remove And To Fit The Bushes For The Balance Weights - Perkins New 1000 Series Workshop Manual

5
To remove and to fit the bushes for the balance weights
1 Press the bushes out of the balancer frame and the rear cover with a suitable adaptor.
2 Clean the parent bores and lubricate them with clean engine lubricating oil.
3 Make a suitable adaptor to the dimensions given in (A3). Fit a bush onto the adaptor. Press the bush (B4)
into the parent bore in the rear of the balancer frame (B3), in a continuous movement, until the shoulder of the
adaptor is against the rear face of the balancer frame. In this position the rear face of the bush should be 3,25/
3,30 mm (0.128/0.130 in) from the rear face of the balancer frame (B). Repeat this operation for the other bush.
4 Fit a bush (B1) onto the adaptor and put it into position at the front end of one of the parent bores in the rear
cover (B2). Press in the bush, in a continuous movement, until the shoulder of the adaptor is against the front
face of the rear cover. In this position the front face of the bush should be 3,25/3,30 mm (0.128/0.130 in) from
the front face of the rear cover (B). Repeat this operation for the other bush.
31,70
3,25/
3,30
3
37,84 42 50,8
2
38
A
122
This document has been printed from SPI². Not for Resale
2,5/3,0
17,0/17,8
1
38 28,45 34,3
29,26 23,5
130/131 27
MILLIMETRES
A0118
3,25/3,30mm (0.128/0.130in)
4
3
B
Workshop Manual, TPD 1350E, Issue 4
New 1000 Series
Operation 5-23
3,25/3,30mm
(0.128/0.130in)
1
2
0,19/0,40mm
(0.007/0.016in)
A0119