Perkins New 1000 Series Workshop Manual page 146

6
New 1000 Series
7 For engines that use the idler gear assembly with needle roller bearings; Release the three setscrews,
remove the plate of the idler gear (C1). Remove the front thrust washer (C2), the front spacer (C3) and the
gear (C4). Remove the two needle roller bearings (C5), if these are to be used again, they should be fitted in
their original positions. Remove the rear thrust washer (C6) and the rear spacer (C7). Remove the hub (C8).
1 2 3 4 5 6 7 8
C
A0132
132 Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale