Perkins New 1000 Series Workshop Manual page 294

12
New 1000 Series
5 Fit the key to the keyway and put the pulley onto the pump shaft. Put the plain washer and the spring washer
in position onto the pulley. Fit the nut and tighten it to 77 Nm (57 lbf ft) 7,9 kgf m.
Note: It may be necessary to fit two setscrews into the holes for the fan to enable a lever to be used to prevent
rotation of the coolant pump shaft when the nut for the pulley is tightened.
6 Connect the hoses to the coolant pump and tighten the clips.
7 Fit the fan belt, see Operation 14-3.
8 Fit the fan, see Operation 12-19.
9 Fill the cooling system.
280 Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale