Perkins New 1000 Series Workshop Manual page 346

15
Caution: If the support bracket is mounted on the oil filter head, check that the nuts for the filter head are
tightened correctly before the compressor support bracket is fitted.
8 Put the support bracket (E4) in position between the cylinder block or the filter head and the compressor.
Loosely fit the fasteners (E5) the spacer (E2), if fitted, and the setscrews (E3). Adjust the support bracket to
ensure that there will be no tension on the compressor. Tighten the two setscrews to 22 Nm (16 lbf ft) 2,2 kgf m
for the setscrews (E3) and 44 Nm (33 lbf ft) 4,5 kgf m for the fasteners (D5).
Note: Spacers (D2) are used between the bracket and the body of the 1W150R compressor.
9 Check that the "O" ring in the cover for the rear of the compressor is not damaged. Fit the cover and tighten
the setscrews.
10 Ensure that there is no restriction in the oil pipe (E6) between the engine and the compressor. Before the
oil pipe is connected to the compressor, ensure that the engine stop solenoid is disconnected or that the engine
stop control is in the 'stop' position. Operate the starter motor until a free flow of oil comes from the oil pipe.
Connect the oil pipe. Connect the engine stop solenoid.
11 Connect the compressor coolant pipes (E1) and the air pipes to the compressor.
12 Fill the engine cooling system. Operate the engine and check for leakage of oil, coolant and air from the
compressor.
2
3
1
4
5
D
332
This document has been printed from SPI². Not for Resale
1
7
6
E
A0069
Workshop Manual, TPD 1350E, Issue 4
New 1000 Series
2
3
5 4
A0294