Operation 10-11 To Remove And To Fit (Four Cylinder Engines) - Perkins New 1000 Series Workshop Manual

10
To remove and to fit (four cylinder engines)
Special requirements
Consumable products
Description
POWERPART Retainer (oil tolerant)
1 Support the front of the bearing cap. Put a suitable adaptor on the small diameter of the idler shaft and press
the idler shaft out of the bearing cap.
2 Ensure that the idler shaft and the hole in the bearing cap are clean. Support the rear of the bearing cap and
ensure that the cap will not move when the idler shaft is pressed in. Apply POWERPART Retainer (oil tolerant)
to the small diameter of the idler shaft. The idler shaft for four cylinder engines is not retained by a pin.
If the idler shaft (A3) has an oil hole ensure that the hole (A2) in the idler shaft is at the top and that the flat
(A1) is at the bottom before the shaft is pressed into the bearing cap.
Enter the chamfer of the idler shaft into the hole. Ensure that the idler shaft is square to the bearing cap and
press in the shaft onto its shoulder. Remove the surplus POWERPART retainer.
A
202
This document has been printed from SPI². Not for Resale
Part number
21820603
1
2
3
A0229
New 1000 Series
Operation 10-11
Workshop Manual, TPD 1350E, Issue 4