Crankshaft Pulley - Perkins New 1000 Series Workshop Manual

5
New 1000 Series

Crankshaft pulley

To remove and to fit (four cylinder engines) Operation 5-1
To remove
1 Remove the drive belt(s), see Operation 14-3.
2 Release the three setscrews (A2) which hold the pulley and remove the setscrews, the thrust block (A1) and
the pulley (A3).
3 Clean the components and check for damage. Renew damaged components.
To fit
1 Put the pulley in position on the crankshaft. Lubricate lightly the threads of the setscrews with engine
lubricating oil. Lubricate the main lip of the seal with clean engine oil. Fit the thrust block and the setscrews
and tighten the setscrews gradually and evenly to 115 Nm (85 lbf ft) 11,8 kgf m.
2 Check each setscrew again to ensure that they are still to the correct torque.
3 Fit the drive belt(s), see Operation 14-3.
1 2
3
A
A0357
Workshop Manual, TPD 1350E, Issue 4 95
This document has been printed from SPI². Not for Resale